Pulse Home Page for Data Communications and Wide Area Networking

Wireless Bridge
Point to Point
-------------
PTP 600
PTP 600 Broadband Wireless IP radio

Specifications


RF band    5.725 GHz�5.875 GHz* 5.470 GHz�5.725 GHz*

Channel size 30 MHz

Channel selection By intelligent Dynamic Frequency Selection (i-DFS) o) or manual intervention; automatic selection on start-up and continual adaptation to avoid interference

Transmit power Varies with modulation mode and settings from -7 dBm to 25 dBm

System gain Integrated: Varies with modulation mode; up to 167 dB using 23 dBi integrated antenna**

Connectorized: Varies with modulation mode and antenna type**

Receiver sensitivity Adaptive, varying between -91 dBm and -58 dBm

Modulation Dynamic; adapting between BPSK and 256 QAM

Error correction FEC/ARQ

Duplex scheme

5.4 GHz: Symmetric Fixed TDD; same frequency Tx/Rx

5.8 GHz: Symmetric Fixed TDD; same or split frequency Tx/Rx where regulations permit

Antenna: type/gain/B/W Integrated: Integrated flat plate 23 dBi /7�

Connectorized: Can operate with a selection of separately-purchased single and dual polar antennas through 2 x N-type female connectors (check local regulations prior to purchase)

Range Up to 124 miles (200 km)***

Security and encryption Proprietary scrambling mechanism; optional FIPS-197 compliant 128-bit and 256-bit AES Encryption

* Regulatory conditions for RF bands may vary by geographic location and should be confirmed prior to system purchase

** Gain, maximum transmit power and effective radiated power may vary based on regulatory domain

*** In all cases the range limit is set by the latest software release

Ethernet Bridging

Protocol IEEE 802.3

User data throughput Dynamically variable up to 105 Mbps at the Ethernet (aggregate)

Integrated and Connectorized Lite: Dynamically variable up to 52 Mbps at the Ethernet (aggregate)

Latency <1 ms average each direction

QoS 802.1p (4 levels)

Interface 110 / 100 / 1000 Base T (RJ-45) � auto MDI/MDIX, 1000 Base SX option

T1/E1 Interface G703/G704 G823/G824

Integrated and Connectorized: Provides dual T1/E1 ports

Integrated and Connectorized Lite: Provides a single T1/E1 port

Management & Installation

LED indicators Power status, Ethernet link status and activity

System management Web or SNMP v1/v2c using MIBII and a proprietary PTP MIB; Canopy� Prizm

Installation Built-in audio and graphical assistance, plus voltage output for link optimization

Connection Distance between outdoor unit and primary network connection: up to 330� (100 meters)

Lightning protection Built into the ODU; an external PTP Lightning Protection Unit (PTP-LPU) end device is required near the base of the tower or wall at the cable entrance point leading to the network to protect the indoor LAN equipment

Physical

Dimensions Integrated Outdoor Unit (ODU): Width 14.5" (370 mm), Height 14.5" (370 mm), Depth 3.75" (95 mm)

Connectorized ODU: Width 12.2" (309 mm), Height 12.2" (309 mm), Depth 4.1" (105 mm)

Powered Indoor Unit (PIDU Plus): Width 9.75" (250 mm), Height 1.5" (40 mm), Depth 3" (80 mm)

Weight Integrated ODU: 12.1 lbs (5.5 kg) including bracket

Connectorized ODU: 10.4 lbs (4.7 kg) including bracket

PIDU Plus: 1.9 lbs (864 g)

Wind speed survival 150 mph (242 kph)

Power supply Integrated with Indoor Unit

Power source 90�240 VAC, 50�60 Hz / 36-60V DC; redundant powering configurations supported

Power consumption 55 W max

Environmental & Regulatory

Operating temperature -40�F (-40�C) to +140�F (+60�C), including solar radiation

Protection and safety UL60950; IEC60950; EN60950; CSA-C22.2 No. 60950

Radio 5.8 GHz: USA CFR 47 Part 15.247, Canada IC RSS-210 Issue 7, Europe EN 302 502, Eire ComReg 03/42, UK IR2007

5.4 GHz: Europe EN 301 893, Canada IC RSS-210 Issue 7

EMC USA CFR 47 Part 15 Class B, Canada CSA Std C108.8 1993 Class B, Europe EN 55022 CISPR 22, Europe EN 301 489-4

 

 



 

 

RF band     2.496 � 2.690 GHz*

Channel size Configurable to 5, 10, 15 or 30 MHz (30 MHz is not FCC compliant)

Channel selection Fixed Frequency (US BRS/EBS Band Plan)

Lower Band � 2496 MHz to 2572 MHz

Middle Band � 2572 MHz to 2614 MHz

Upper Band � 2614 MHz to 2690 MHz

Transmit power Varies with modulation mode and settings from 0 to 23 dBm

System gain Integrated: Varies with modulation mode; up to 154 dB using 18 dBi integrated antenna**

Connectorized: Varies with modulation mode and antenna type**

Receiver sensitivity Adaptive; varying between -95 and -59 dBm

Modulation Dynamic, adapting between BPSK and 256 QAM

Error correction FEC

Duplex scheme Time Division Duplex (TDD) and Half Duplex Frequency Division Duplex (HD-FDD), Dynamic or Fixed ratio

Antenna Integrated: Integrated flat plate 18 dBi, 20 degree beam width

Connectorized: Can operate with a selection of separately-purchased single and dual polar antennas through 2 x N-type female connectors (local regulations should be checked prior to purchase)

Range Up to 124 miles (200 km)***

Security and encryption Proprietary scrambling mechanism; optional FIPS-197 compliant 128/256-bit AES Encryption

* Regulatory conditions for RF bands should be confirmed prior to system purchase

** Gain, maximum transmit power and effective radiated power may vary based on regulatory domain

*** In all cases the range limit is set by the latest software release

Ethernet Bridging & T1/E1

Protocol IEEE 802.3

User data throughput Dynamically variable up to 300 Mbps at the Ethernet (aggregate):

5 MHz Channel: Up to 48 Mbps

10 MHz Channel: Up to 100 Mbps

15 MHz Channel: Up to 151 Mbps

30 MHz Channel: Up to 300 Mbps (not FCC compliant)

Latency one way <1 ms typical in 30 MHz channels <1.5 ms typical in 10 MHz channels

<1.2 ms typical in 15 MHz channels <2 ms typical in 5 MHz channels

Packet prioritization IEEE 802.1p, single priority level

Ethernet interface 10 / 100 / 1000 Base T (RJ-45), auto MDI/MDIX, optional 1000 Base SX

T1/E1 Interface G703 / G823 and G704 / G824

Single T1/E1 in 10 and 15 MHz channels

Dual T1/E1 in 30 MHz channels

Management & Installation

LED indicators Power status, Ethernet link status and activity

System management Web or SNMP V1/2c using MIB-II and proprietary PTP MIB; Canopy� Prizm

Installation Built-in audio and graphical assistance for link optimization

Connection Distance between outdoor unit and primary network connection: up to 330� (100 meters)

Physical

Dimensions Integrated Outdoor Unit (ODU): Width 14.5" (370 mm), Height 14.5" (370 mm), Depth 3.75" (95 mm)

Connectorized ODU: Width 12.2" (309 mm), Height 12.2" (309 mm), Depth 4.1" (105 mm)

Powered indoor unit (PIDU Plus): Width 9.75" (250 mm), Height 1.5" (40 mm), Depth 3" (80 mm)

Weight Integrated ODU: 12.1 lbs (5.5 kg) including bracket

Connectorized ODU: 9.1 lbs (4.3 kg)

PIDU Plus: 1.9 lbs (864 g)

Wind speed 202 mph (325 kph)

Operating temperature -40�F (-40�C) to +140�F (+60�C), including solar radiation

Power supply Integrated with Indoor Unit

Power source 90�240 VAC, 50�60 Hz / 36-60V DC

Power consumption 55 W max

Environmental & Regulatory

Protection and safety UL60950

Radio FCC Part 27

EMC FCC Part 15 Class B

 

 

Wireless Modem and Router Products
Toll Free Email Pulse Catalog International


Copyright© 2012 Pulse, Inc. All rights reserved
Privacy Legal Site-map  :  HelpLogin