Interface Conversion
-------------
Balun Rack
for E1

Features

• Conversion between dual 75 ohm coax interface and twisted pairs for E1 applications (2.048 Mbps)

• Available in 8 or 16 ports

• Enables standard ISDN primary rate installation over existing coax cables

• No AC or DC power required

• Insensitive to signal direction

• Immediate installation

• Miniature, lightweight Balun

Description

• The Balun (coax to twisted pair converter) enables any E1 equipment with coax interface to operate over two twisted pairs (4-wire interface), as shown in Figure 1.

• Balun Racks back-to-back allow 4-wire ISDN equipment to operate over existing coax cables (see Figure 2).

• The Balun is insensitive to the direction of the signal, allowing transmit and receive lines to be reversed without affecting operation.

• The E1 Balun is a miniature, lightweight Balun. It operates without AC or DC power and provides up to 1000V isolation voltage for protection against AC and DC over voltage on the line