 |
|
|
|
STANDARDS FCC and CSA standards
CE Approved
WARRANTY Limited three-year warranty
PHYSICAL INTERFACE RS-232/V.24: DB-25
RS-530/422: DB-25
V.35: DB-25 or 34-Pin
X.21: DB-15
TRANSMISSION RS-232/V.24, RS-530/422,
V.35, and X.21
PROTOCOLS Transparent to all protocols
CONTROL VIRtuoso software or
ASCII Terminal
CONTROL INTERFACE 1200, 2400, 4800, 9600,
or 19,200 bps
8 Data Bits, 1 Stop Bit
No Parity
SYSTEM CAPACITY Ability to be stacked and
daisy-chained
PROGRAMMED ALARMS (RS-232, RS-530, V.35)
(TERMINAL OR VIRTUOSO)
SD Send Data - Present/Absent
RD Receive Data - Present/Absent
SCT Serial Clock Transmit - Present/Absent
SCR Serial Clock Receive - Present/Absent
RTS Request to Send - High/Low
DTR Data Terminal Ready - High/Low
DCD Data Carrier Detect - High/Low
DSR Data Set Ready - High/Low (Terminal only)
CTS Clear to Send - High/Low (VIRtuoso only)
PROGRAMMED ALARMS (X.21)
(TERMINAL OR VIRTUOSO)
T Transmit Data - Present/Absent
R Receive Data - Present/Absent
I Indicate - High/Low
C Control - High/Low
S Signal Element Timing - Present/Absent
B Byte Timing - Present/Absent
SIZE 19.0� (48.26 cm) wide,
14.0� (35.56 cm)
deep by 7.0� (17.8 cm) high maximum
WEIGHT 29 lbs. complete system with DB-25/DB-15
connectors
39 lbs. complete system with V.35 connectors
CIRCUIT MODULE ACTIVITY INDICATORS
RS-232, V.35, RS-530
SD, RD, CD, DTR, and RTS
X.21
T, R, I, C, and S
CONTROL MODULE ACTIVITY INDICATORS
RS-232, V.35
SD, RD, RTS, CTS, DSR, CD,SCT, SCR,
DTR, RI, and SCTE
RS-530
SD, RD, RTS, CTS, DSR, CD,SCT, SCR,
DTR, and SCTE
X.21
T, R, I, C, S, and B
POWER REQUIREMENTS
AC Source - 115/230 Volt input to the
dual redundant power supplies
AC Fuse: 0.75 AMP at 115V
0.375 Amp at 230V
Frequency - 50/60 Hertz +/- 3%
Energy Rate - 50 VA
Receptacle - 3-Prong, Grounding
OPERATING ENVIRONMENT
Temperature - 0 to 40 Degrees Celsius
Relative Humidity - 10% to 80%, non-condensing
|
 |
|
Email
