Signaling Conversion
-------------
SP201

Specifications

STANDARDS CONFORMANCE

• R1 Q.310 –Q.331

• R2 Q.400 –Q.490

• DTMF BellCore TR-TSV-002275,Subsection 6.13

• SS7 BellCore TR-NWT-00246,ANSI T1.111a,T1.112,T1.113a,T1.114,
  T1.116,T1.234 –T1.236

• C7 ITU-T White Book:Q.767,Q.701 Q.704,Q.705,Q.708,Q.709,Q.780 –
  Q.782,Q.784,Q.788

• ISDN-ETSI ETSI 300-102,Q.931,Q.921

• ISDN-NI2 BellCore TR-NWT-001268, TR-NWT-002343;Q.931,Q.92

Agency Compliance

Safety:

EN 60950,European Safety (CE Mark)
UL 1950 3rd Edition, U.S.Safety
FCC Part 15,Sub-part J,Class A

Immunity:

EN 50082-1:1997
Emissions & EN 55022 (Europe) Immunity

HARDWARE SPECIFICATIONS

Physical:

Height 1.75 in.(4.45 cm)
Width 19 in.(48.26 cm)
Depth 10 in.(25.4 cm)

Input:

Power -42 to -56 VDC
100 to 240 VAC,50 to 60 Hz

Environmental:

Temperature 32 ° to 122 ° F ((0 ° to 50 ° C))
Humidity Up to 95%non-condensing
Altitude Up to 10,000 ft.(3,048 m)

SYSTEM CAPACITY

Aggregate Cards: One per chassis
Interfaces: Up to four E1 or T1 trunks (or eight full duplex trunks) per chassis
Channels: Up to 31 per trunk; up to 248 per chassis
SS7/C7 Signaling Links: Four per chassis

INTERFACE SPECIFICATIONS

Framing:

E1:G.732 or G.704
T1:D4SF or D4ESF

Bit Rate:

E1:2,048 Mbps
T1:1.544 Mbps

Clocking:

E1:± 30 ppm internal
E1:±100 ppm external
T1:±30 ppm internal
T1:±150 ppm external

Impedance:

E1:120 ohm balanced
E1:75 ohm unbalanced
T1:100 ohm balanced

Coding:

E1:AMI or HDB3
T1:AMI or B8ZS

Alarms:

E1:Loss of carrier signal, multi-frame carrier signal, sync; alarm
indication signal (AIS); receipt of remote alarm; receipt of multi-frame remote alarm

T1:Loss of carrier signal; loss of frame; receipt of alarm indication
signal (AIS); receipt of remote alarm Diagnostics E1/T1:signaling state report, digit report

Performance

E1:G.703,G.704,G.732,G.823
T1:ATT Pub.62411